Cage Mill with Flash Dryer

Cage Mill with Flash Dryer De-lump and dry materials with up to 40% moisture in one step. Completely welded shell handles temperatures up of 1200°F. Standard cage mills only handle temperatures up to 300°F. Hot air with temperatures from 1000°F to 1200°F is introduced with the feed material and conveys de-lumped and dried material through the uptake duct of the cage mill. Use unit with hot gas stream from within plant for tremendous fuel savings. Control moisture level of incoming feed to maintain a 1% to 2% moisture level.

Key Benefits

De-lump and dry in one unit
Handles a wide range of moisture levels
Low horsepower requirement
Low mill speed depending on material and moisture content
Re-circulating oil system included with unit to control bearing temperature
Capacities to 80 TPH
Click here to see applications
Click here to see the PDF Literature.

Cage Mill with Flash Dryer Maximum Capacities
Model	Capacity	Mill Weight (lbs)	Horsepower
41	up to 10 TPH	6,400	30 - 50
67	up to 35 TPH	8,500	40 - 75
80	up to 50 TPH	14,000	50 - 100
89	up to 60 TPH	23,500	60 - 125
104	up to 80 TPH	26,000	75 -150
*NOTE:* Capacity may vary due to materials bulk density and CFM requirement for drying. Mill weight may vary due to design requirements.

Your solution to size reduction™
129 Franklin Street • PO Box 299 Aurora, IN 47001
Telephone: (800) 262-5401 or (812) 926-0038
Fax: 812-926-3482 • sales@stedman-machine.com